Page 1 of 1

Cerevo FlexTally use with ATEM

PostPosted: Wed Jan 13, 2021 8:23 am
by ikorolev
Hello everyone

Just would like to start off with: this is my first post on this forum so apologies if I posted this in the wrong place, there was a previous answer to my question that I missed, or I did not provide enough detail about my issue.

My issue is: trying to connect the Cerevo FlexTally tally light system with my blackmagic television studio pro 4K. Does anyone have any experience connecting this hardware together?

I got the lights to communicate with each other but I cannot get the lights to switch with the ATEM. I’ve followed all of the troubleshooting in the official manual and still no luck. I believe it has something to do with the way I connected the lights to the LAN but I cannot figure it out. Any help will be appreciated, thanks.

Re: Cerevo FlexTally use with ATEM

PostPosted: Wed Jan 13, 2021 11:42 pm
by Roman Pytkin Pekarek
I dont know FlexTally .. But U must setup somewhere IP adress of ATEM switcher ..

Re: Cerevo FlexTally use with ATEM

PostPosted: Fri Jan 15, 2021 11:52 pm
by ikorolev
Yeah. I did set-up the correct IP address but then the tally lights do not work when the ATEM is being used.