Sat Feb 06, 2021 10:34 pm
I've done some searching and haven't had any luck.
At our church, we have an ATEM switcher that we run from the software on a Mac.
I can get the macros to work just fine with normal preview/program switching, but can't seem to figure out how to include the extra outputs in this.
Essentially we have 2 outputs we change at certain points, one is going to a center screen, one is a distributed feed. The outputs are listed at the top of the software in the toolbar. We simply select the output, then select what we feed it from the drop down.
Is there any way to include this output switching in the Macros so it's easier? Or can I only control the preview/program feed with a macro?
I'm going to assume I am leaving out crucial info and will need to clarify, I am fairly new to the ATEM software and not sure how to even ask this question. I'm including a screenshot of the toolbar menu I am talking about. Thanks in advance
- Attachments
-
- Screen Shot 2021-02-06 at 5.24.13 PM.png (26.04 KiB) Viewed 516 times