ATEM Mini Series: MIC Inputs - Stereo signal
Posted: Mon Apr 12, 2021 7:17 pm
I have no access to the hardware at the moment so I need to ask here instead of testing: If I connect a STEREO signal to one of the MIC inputs, will this:
1) be mixed down to a mono signal
2) result in a "normal" stereo audio recording with L/R channels
3) Is it possible to route a stereo signal coming in on MIC 1 internally to TWO channels?
I will be using a Rode Wireless Go II setup to record two speakers. The receiver outputs the signal via a stereo jack, one speaker on the left, one on the right channel. The idea is to be able to a) adjust both speakers during the live stream seperately via the ATEM's software mixer and b) to be able to edit both speakers in post as each one has it's own channel of the stereo recording.
I know the Wireless Go II transmitters are capable of recording on board. But being able to adjust levels via the software mixer would be great.
1) be mixed down to a mono signal
2) result in a "normal" stereo audio recording with L/R channels
3) Is it possible to route a stereo signal coming in on MIC 1 internally to TWO channels?
I will be using a Rode Wireless Go II setup to record two speakers. The receiver outputs the signal via a stereo jack, one speaker on the left, one on the right channel. The idea is to be able to a) adjust both speakers during the live stream seperately via the ATEM's software mixer and b) to be able to edit both speakers in post as each one has it's own channel of the stereo recording.
I know the Wireless Go II transmitters are capable of recording on board. But being able to adjust levels via the software mixer would be great.