- Posts: 7
- Joined: Tue Jan 22, 2013 11:41 pm
I plugged in my ATEM Mini Extreme ISO for the first time today. I did the prompted firmware update and I'm sitting at 8.6.1 and using an M1 Macbook Pro running Big Sur.
I set up for the preview/program bus with the ATEM Setup utility (though a version of this problem exists in cut bus mode too)
When I select IN1 as a preview on the ATEM and take it, the "1" button on the ATEM lights up red as expected but so does IN3 (but in a half-lit kind of way). If I preview IN2, IN3 becomes yellow. If I select IN5 in preview (IN1 is still hot) IN3 is red, IN5 is green but so is IN7 (half green).
Do I have a bad ATEM? The white lights for the input volume for each input also flicker. (The software seems to reflect the "real" selections and doesn't show multiple sources in preview or program light the actual hardware does)
I appreciate any troubleshooting thoughts. Image attached showing the problem.
Thanks!
Mike
I set up for the preview/program bus with the ATEM Setup utility (though a version of this problem exists in cut bus mode too)
When I select IN1 as a preview on the ATEM and take it, the "1" button on the ATEM lights up red as expected but so does IN3 (but in a half-lit kind of way). If I preview IN2, IN3 becomes yellow. If I select IN5 in preview (IN1 is still hot) IN3 is red, IN5 is green but so is IN7 (half green).
Do I have a bad ATEM? The white lights for the input volume for each input also flicker. (The software seems to reflect the "real" selections and doesn't show multiple sources in preview or program light the actual hardware does)
I appreciate any troubleshooting thoughts. Image attached showing the problem.
Thanks!
Mike
- Attachments
-
- AMEI_2021-07-27-squashed.jpg (712.13 KiB) Viewed 611 times