Blackmagic Forum

Does the ATEM Mini Extreme Iso have an on/off switch? Darned if i can find one. Is unplugging it the only way to power down? Or was it designed to be left on forever? The nanual downt say anything about it.

There is no on/off switch. Put it on a switched circuit to control it.

Wow... just wow. Poor design to omit a $4 switch

No, it would be worse design to have a switch that could accidentally take your entire broadcast offline. Spend the $4 on a switched power strip if you need to turn things off regularly.

Or just unplug it from the rear of the console.

For anyone looking for a way to have a power switch to your ATEM Mini line of switchers. Check out this one on https://www.ebay.ca/itm/255202369285

I've been using it for 3 months and it works great. It is well built and very convenient. Also has locking connectors so power can't get accidently pulled out like some of the cheap in-line power switches found on Amazon and eBay.

Hope fully this helps you out as it took me awhile to find the right kind of switch for my ATEM Mini Extreme.

mapleleafs0101 wrote:For anyone looking for a way to have a power switch to your ATEM Mini line of switchers. Check out this one on https://www.ebay.ca/itm/255202369285

I've been using it for 3 months and it works great. It is well built and very convenient. Also has locking connectors so power can't get accidently pulled out like some of the cheap in-line power switches found on Amazon and eBay.

Hope fully this helps you out as it took me awhile to find the right kind of switch for my ATEM Mini Extreme.

Thank you! You are a life saver!