Blackmagic Forum

Hi,
my name is Faro and I have an Atem 2ME 4k Production Studio s/n 2505184, and I can't use the Talkback system.
I`m using the 7.2 software, and I have many Hyperdecks, cameras adaptrs and 2 Studio camera connected to the Atem by a Blackmagic 40x40 videohub.
I followed the manual instructions but I have only a noise nearby 1000hz, in the camera intercom connection and in the Atem talkback connection.
Can you help me?
Thanks

Hello Beto. You are probably getting feedback from the Hyperdecks if they are connected both as inputs and outputs. Disconnect either the input or output and see if that is the issue. Some Hyperdeck models let you turn off the upper 8 channels of audio which would also solve the problem.

Regards, Gary

Thanks Gary
I'll try and let you know
By

Hi Gary
It's work fine now. Thanks
One more question: Ho can I desable audio channels on Hyperdeck
Thanks

Hello Beto. The later model Hyperdecks have a menu selection for 2,4,8 and 16 channels. This is where you can set 8 or lower preventing the upper channels from feeding back. The older models do not have this menu setting.

Regards, Gary