Hi all again, thank you for your responses.
Now we have the new Atem Constellation 2M/E working (What an upgrade with the previous one!)
Now the intercom is working with ATEM's own. I mean, the mixer and camera operators are interconnected with the Constellation system.
From the old ATEM system we keep an old "Production Intercom MS200" with all the belts. It have a:
1X front 4-pin XLR for the headset
Pin 1 Mic common
Pin 2 Mic hot
Pin 3 Headphone common
Pin 4 Headphone hot1X output for paging
Pin 1 Sleeve Ground (Shield)
Pin 2 Tip Hot (+) Signal
Pin 3 Ring Cold (-) Signal6X 3-pin XLR connectors for 6X belts to connect a headset to each one. (The Belt (BP.15 PI INTERCOM) converts the 3-Pin XLR with power to a conventional 4-Pin XLR Headset)
Pin 1 Ground (Shield)
Pin 2 Power (+30 VDC)
Pin 3 Audio
So my question is:Can I interconnect through the RJ45 of the Constellation one of the 4-Wire connections to my Production Intercom MS200? For example, connecting it to the front 4-pin XLR or to one of the belts. So I can communicate with more people than a camera operator.
I don't know if im being too dumb doing this conversion or it really that easy.
Thank you so much for your responses and your patience.