Can multiple ATEM’s be networked to be used in Macro’s?
Posted:
Wed Sep 28, 2022 10:10 pmby Clinton Vadnais
I have a new need that I’m brainstorming. I’m not a guru with Streamdeck companion. Can a macro be created that would for example change state on a Mini Pro Extreme ISO and a Mini in one move?
Re: Can multiple ATEM’s be networked to be used in Macro’s?
Posted:
Thu Sep 29, 2022 7:20 amby Dave Del Vecchio
Yes, you could set up a button in Bitfocus Companion to send commands to multiple ATEM switchers. Note that Companion also has a web interface with on-screen buttons, so you can use it without a Stream Deck if you don't need the hardware control surface.
If you are asking about the built-in ATEM macros, those macros are executed internally by the switcher, so any actions performed by the macro are limited to the switcher the macro is running on.
Re: Can multiple ATEM’s be networked to be used in Macro’s?
Posted:
Thu Sep 29, 2022 9:07 pmby Clinton Vadnais
Thank you. That’s promising! I will try to figure it out when I get a chance. I appreciate the tip. I do have a couple of Streamdecks and have used Bitfocus Companion but it’s been years and I didn’t go too deep. Hopefully this will solve my particular problem.