Page 1 of 1
ATEM 2 output sync problem.
Posted:
Tue Jan 31, 2023 1:28 pmby tommy-cash
Hello,
I was wondering is there a way that I can get 2 ATEM outputs in sync or even 1 ATEM 2 outputs in SYNC.
With 2 Atems it seems like network is causing the issue, but with 1 Atem, I cannot sent "switching" command for both outputs at the same time.
Re: ATEM 2 output sync problem.
Posted:
Fri Feb 03, 2023 4:07 amby Tim_Partridge
You could try recording a macro to switch both outputs on one ATEM, then triggering the macro. That might work quicker since the sequence is done inside the ATEM.
Tim
Re: ATEM 2 output sync problem.
Posted:
Fri Feb 03, 2023 8:58 amby Xtreemtec
We done this with Companion to switch ME1 and ME2 at the same time. And that was frame accurate.
Re: ATEM 2 output sync problem.
Posted:
Fri Feb 03, 2023 8:41 pmby ettnoll
Just so you don't try to solve something that actually is less complicated than it seems: you know that you can route PGM to an AUX, right? That will output the same video on multiple outputs.
Re: ATEM 2 output sync problem.
Posted:
Fri Feb 10, 2023 6:56 amby tommy-cash
Thank you, using macros help. And found easy way to trigger with nodejs. Thanks!