Mon Mar 20, 2023 8:56 pm
Setup: ATEM TV HD8, 2 GFX computers input to channels 2 & 9. 3 Hyperdeck minis connected over ethernet to the ATEM HD8. Program SDI running to the first hyperdeck and looped out into the 2nd and 3rd deck. 1 Control Macbook pro, running the ATEM control software and connected to the ethernet port on the ATEM HD8.
The ATEM HD8 sees the 3 Hyperdeck minis under the settings on the board however the control software can not connect to them. The rest of the control software works and switches the board just fine. I have seen posts similar to this but the ip address on the board, hyperdecks and control software are all the same already. The mackbook is a 2021 with an Apple M1 Pro chip. Running Ventura 13.2.1 OS.
Please advise Thank you
ATR Treehouse Dennis Pouliot Jr. | Technical Director
812 Charles St. Providence, RI 02904
dpouliot@atrtreehouse.com • www.atrtreehouse.com
p: 401-751-3121 c: 401-450-9548
Technical solutions for presentations, performances, and special events.