Page 1 of 1
ATEM MINI EXTRE CCU CONTROL SYNC
Posted:
Wed Mar 22, 2023 5:05 pmby fvalentini72
Is there a way to bidirectionally control the parameters of a pocket cinema camera 6k pro from the atem mini extreme? if i connect the camera via hdmi and change a parameter (iso or shutter or color temperature) on the pocket cinema camera 6k pro in the atem control software the parameter does not change vice versa yes.
Re: ATEM MINI EXTRE CCU CONTROL SYNC
Posted:
Thu May 18, 2023 4:00 pmby Fenixt
Hey there. I just got an atem extreme iso and the bmpcc 6k g2. Over HDMI, just using the physical atem buttons. I am have tested that I can control the shutter and even the focus on the sigma art lens.
There is a chance you may need a firmware upgrade on camera and/or atem. Another possibility is your HDMI cable isn't passing the signal. YouTuber Linus Tech Tips did a thing on HMDI cables and found a lot of the cables they tested didn't even work to spec.
Re: ATEM MINI EXTRE CCU CONTROL SYNC
Posted:
Thu May 18, 2023 4:21 pmby Howard Roll
The OP is going the other direction. There is no communication from the camera to the Atem. The Atem is always sending control data (TX), but never receives any (RX).
Good Luck