Page 1 of 1
Atem Sdi Pro Iso / input interlaced signals
Posted:
Thu Mar 23, 2023 7:24 amby Etruxo
HI
We installed the mixer but found that it "doesn't see" the interlaced formats (i50 and/or i60) being input, even though these are listed in the stated specifications.
Where do we go wrong?
Suggestions?
Thanks
Re: Atem Sdi Pro Iso / input interlaced signals
Posted:
Thu Mar 23, 2023 11:12 pmby Roman Pytkin Pekarek
It must work .. I was used it with 1080i50 on input and everything was fine ..
Re: Atem Sdi Pro Iso / input interlaced signals
Posted:
Fri Mar 24, 2023 6:21 amby ManchesterV
The switchers are progressive.
Anything sent interlaced will be converted to whatever frame rate the switcher is set to.
So if you set the switcher to 50p and send it a 50i or 50PsF signal the ATEM will convert the 50i to 50p automagically.
You cannot get interlaced out of an ATEM Mini/SDI.
Re: Atem Sdi Pro Iso / input interlaced signals
Posted:
Mon Mar 27, 2023 12:28 pmby Joseph Villegas
An strange behavior that I found;
Cameras in 1080 i 59.94
Atem in 1080 P 60
The conversion result in visible 30 fps
But, if I set cameras in 720 P 60, I get back the 60 fps...