Assigning Super Source to Panel Button

How do I assign a super source to one of the physical buttons (1-20) on the front panel of the ATEM 2 M/E Constellation HD?

I setup SuperSource 1 and so far the only way I can call it up into Preview or Program is to click the 'SS1' button in the ATEM Software Control.

It would be great if I can select SuperSource 1 the same I select any of my camera inputs.

Thank you!

Hi,

i also have an Constellation 2ME.

I dont think, that it is possible to do that on the Front Panel.

Get Compagnion with StreamDeck.
Or Third Party Controller.

Regards

Cyprian +1 from me ...

Streamdeck is your friend .. Its MUST HAVE tool for you ..

If you don't mind losing an output and input, and you don't mind the extra frame of delay, routing the supersource out of one of the aux outputs and then back into an input will allow you to put it on the front panel.

The front panel, in common with all Atem's, cannot be remapped.