Blackmagic Forum


https://forum.blackmagicdesign.com/

How to select Preview Source on Atem Mini Pro ISO

https://forum.blackmagicdesign.com/viewtopic.php?f=4&t=181236

Page 1 of 1

How to select Preview Source on Atem Mini Pro ISO

PostPosted: Fri May 12, 2023 2:54 pm
by CollinEmber
Hi,

I'm running Atem Software Control 9.0.1. In "Switcher" view I can select which HDMI source I want to see on Preview. How do I do that with the hardware device? I couldn't find anything about it.

I remember seeing a green button on my atem once, but i think that was before I updated.
Configuration is set to Program/Preview for transition control, Output is set to multiview.

Would be nice if somebody could point me in the right direction. Thanks!

Re: How to select Preview Source on Atem Mini Pro ISO

PostPosted: Fri May 12, 2023 5:18 pm
by LouisBacker
Connect your ATEM Mini via it's USB-C port to a computer loaded with ATEM Setup software. (or ethernet, if you've already done an IP configuration).

Once the ATEM is recognised and its' picture shows in the GUI, hit the picture to access the Setup GUI.

Scroll down to Panel then Switching Mode and select Program Preview; save and exit. The numbered switches on your unit will now also act as Preview buttons, with the active preview channel illuminating green and the live channel, red (which is likely how your unit was set before it was updated). All you then do is hit CUT or AUTO on your Atem panel to effect a Take.