Blackmagic Forum

Hi all,

i write here because i tried to search one solution on web but i didn't find nothing and i hope somebody can help me.

i use h2r grafichs for insert the grafichs on air. i connected on my key 1 on atem mini extreme iso.

if i use software for change cameras i don' have a problems. the grafichs rest in position, but if i use the bottons on the atem the grf go off out and i need to push another one more time key1 for restart the grf.

i try to explain better.
use software - cam 1 with grf, change on cam 2 without problems.

when i do the same thing with botton on atem when i pass from cam 1 to cam 2 the grf go off

which is it the problems? or better what can i do for to have always the grf when i use atem with the botton?

It sounds like you have tied the key to the transition. Ensure "key 1" is not lit yellow under "next transition" in software control

I'm a total noob too, so take what I say with a grain of salt. But after trying to figure out how things work today, I found that using the Atem setup software (not the control software) you can toggle the DVE to cut off or stay on during transitions. Strangely, this setting only seems to work on DVE 1 or upstream key 1 (didn't check which is the one, I was using the DVE on USK 1). DVE2 or USK2 would stay on during transitions no matter what the setting was on.

So either change the setting in Atem setup software or use DVE2 or USK2 (one of those, not sure which matters).