Blackmagic Forum

Hello

I have a Macbook Late 2006. I am using for ProPresenter. I connect to the ATEM Television Studio via the DVI to HDMI adapter.

My problem is that I can't get the ATEM to receive the signal. I have the correct resolution from ProPresenter with 1920 to 1080i @60Hz. The laptop recognises the output and assigns a BMD profile but no signal is shown. I have changed the resolutions tried many solutions but to no avail.

I tried my laptop with my Samsung TV via HDMI input and it showed a FULL 1080 resolution with 60hz on the TV.

Is there a special display profile for MacBooks? Is this a problem with the old MacBooks that don't send audio trough the DVI?


Thanks so much

I believe the case is that the ATEM Television Studio doesn't recognize the 60hz. Check the following link to see what is supported.

http://www.blackmagicdesign.com/product ... /techspecs

HI Tony

The supported frequency is 59.98 HZ basically 60hz. I don't think that is the problem. Any suggestions?