Blackmagic Forum

My Hyperdeck Studio mini is connected to my router via a switch as is the Atem extreme. The Atem is picked up by the Software Control app. The hyperdeck setup app does not pick up the hyperdeck if I enter the ip address shown on the hyperdeck menu with DHCP on. If I switch off DHCP and enter a static address, I can set up the hyperdeck in the atem software control. Unfortunately it has to be done every time the units are switched on.

What is stranger is that bitfocus companion connects to the hyperdeck with the DHCP on ip address. Why not the Atem.

(Remote is turned on on the hyperdeck.)