Blackmagic Forum

Hello...
I have multiple files on my HyperDeck Studio Mini (note, not HD Mini).
When I hit Play on any file, it just plays to the end of the card.
Shouldn't it stop playing at the end of that file?
I'm in Play, not Loop Clip or Loop All Clips.
Thanks...
JJ

Hello...
Does anyone know of a way to just play a single file, from the HyperDeck?
I've resorted to using presentation software (like ProPresenter), instead of the HyperDeck, for playback.
I will say that it works quite well, though.
JJ

When you press the PLAY button multiple times you can cycle through the different supported play modes, one of which is single clip play. It's also supported over the netwerk via the Hyperdeck control protocol and used by e.g. Bitfocus Companion and other software to force single clip playback.

eMilty wrote:When you press the PLAY button multiple times you can cycle through the different supported play modes, one of which is single clip play. It's also supported over the netwerk via the Hyperdeck control protocol and used by e.g. Bitfocus Companion and other software to force single clip playback.

Thanks for the information.
Does that also work with the ATEM software?
I don't recall if I was using the play button, on the device, or the software.
JJ

The ATEM software does have a loop button but I think it only toggles between looping and not looping.