Page 1 of 1
ATEM Update each Computer Change
Posted:
Fri Jan 31, 2014 6:01 pmby death_by_avid
I'm trying to get two different computers to control the same Television Studio. They will not be controlling it at the same time. When I switch from one computer to another, I get the "update and run Utility" prompt each time. Is there a way I can set both computers to control the same switcher, but not need the update?
Re: ATEM Update each Computer Change
Posted:
Fri Jan 31, 2014 6:46 pmby Hakan Taube Lyxzen
Have the same software in both.
Hakan
Re: ATEM Update each Computer Change
Posted:
Fri Jan 31, 2014 8:34 pmby death_by_avid
I'm using the same ATEM Software Control in both computers, have them set to different IPs, but when I move the ethernet cable from one computer to the other, it demands an update with the USB cable. That update is what I want to avoid.
Re: ATEM Update each Computer Change
Posted:
Fri Jan 31, 2014 9:39 pmby Thomas Seewald
Are you really shure, that on both computers the same software version is installed ?!
Re: ATEM Update each Computer Change
Posted:
Fri Jan 31, 2014 9:41 pmby Tony_R_BMD
Yes please make sure you have the same software installed on both. It shouldn't prompt you for an update if they're running on the same version.
Re: ATEM Update each Computer Change
Posted:
Mon Feb 03, 2014 9:46 pmby death_by_avid
That did it. One of the computers still had 4.1.1
Thanks