Blackmagic Forum

Hello,

I am using the ATEM TELEVISION STUDIO switcher and I have gotten 2 cameras to operate with my system, but one camera (which previously read before) is no longer reading.

I have troubleshot all cables, restarted the system, changed the resolution settings, adjusted camera output settings and nothing.

Anything sound familiar that can be resolved easy?

Thanks in advance

Do you use the same type of cables? (HDMI or sdi)
If so switch cables between an working camera and the one not working to see if the problem stays at the same input or moves to the other working one. If the problem stays on the same input then there are som problems with that input. If you get picture with the other camera you know that there are problems with the signal from the camera.
It could be that you are using input 3 or 4 and have not set the correct input, there are shared between sdi and HDMI and must be set in the Atem control software.

Hakan