Blackmagic Forum

Hi all!

I have the following setup:

- Atem TVS
- PC with W7 pro 64bit with MXLight software.

Connection between these two is via USB from the TVS to the PC.
When I connect the TVS with the MXLight software it works fine. Recording and previewing works fine. But I'm using it mainly for streaming. But when I start streaming(RTMP) it almost immediately stops. All the settings for my streaminghost are correct.

Anyone any idea?

Other suggestion: is it possible to use Adobe Flash Media Live Encoder via the USB connection?

Regards, Jacco

I can't answer your specific issue with MXLight and streaming. Have you contacted the developer?

On "can you use FMLE with the TVS?" the answer is NO.

i was tested mxlight about 2 weeks .. no problem with rtmp streams ..