ATEM Television Studio HD8 Headset

What would be the recommended talk back headset with a 5-pin XLR that is compatible with the ATEM Televiion Studio HD8. I've been googling but can not find a list of compatible headset.

Following.
I tried a 4 pin to 5 pin adapter with a cheap thomann headset but didnt work

The headset pinout is the same as most within the industry. Any 5 pin Telex, Clear Com, RTS, David Clark, etc., should work. If you’re on the hunt for a budget solution, just make sure the pinout matches.

Good Luck

I tried a 4 to 5 pin adapter as well without success. I had low audio signal when all levels are set to max, but.
It seems tech specs of the headset don't match? Mine has 400 Ohm / 100 mW input power.
A headphone with 80 Ohm (DT 770 Pro) did not work when using pinout 3-GND, 4-left, 5-right.
Any details here from Blackmagic, how to make this work?

Here is discussion about it ..

viewtopic.php?f=4&t=120960

And they said it works .. 3 gnd, 4 left, 5 right

I found that too but it did not work... that's why I asked about the impedance. Maybe Blackmagic has details, which specs to use.