Blackmagic Forum

Hello- Can somebody help me to find the information?
I am setting 2110 Multicast Output in Setup page, but i don't see anywhere to set a destination port number after an Ip address (e.g 231.1.2.3:xxxx). If this can not be set, what is the default destination port number? I can't find it from the manual either. Thanks.

Hello, You can stage it (stage connection) at Tx level with an NMOS orchestrator. The parameter is not exposed by the native client. If you browse the device, you will find it under XXX.XXX.XXX.XXX:8090/x-nmos/connection/v1.y/single/senders/zzzzzzzz-zzzz-zzzz-zzzz-zzzzzzzz/staged with x IP Address, y 1.version of IS-05 version and z the sender id you can find under XXX.XXX.XXX.XXX:8090/x-nmos/connection/v1.y/single/senders . Cheers