ATEM Camera Control Panel Issue

Howdy,

I have an ATEM Camera Control Panel which was working ok but now whenever I do an adjustment on camera 1 it also changes camera 4. The camera 4 controls don't work at all. How do you unlink the two channels?

Cheers
Paul

Your camera “4” currently has an ID of 1, change it back to 4.

Good Luck

Thanks. Had just worked it out after the post. I run a TV Studio at St Andrew’s College in New Zealand and one of the students must have been exploring through the menus and changed things. It’s the only issue when you have 150 enthusiastic and inquisitive students wanting to learn all about everything in a professional broadcast studio. Spend most of my time undoing knots they’ve created in the workflow. At least they’re learning from their mistakes…. Hopefully.