Blackmagic 2110 IP Converter Studio Camera 4K Pro G2

Hello community, can i use the Blackmagic 2110 IP converter to connect 3x Blackmagic studio cameras 4K pro G2, in 3G resolution (SDI-HD 1080i) including RCP-Remote, HD-SDI return, tally and intercom to a ATEM Television Studio HD8 ISO?

I am wondering the same question. Will these power and transport from just being connected on the ATEM side so I only have to run my CAT6 cable to the cameras and have everything good to go? I am on limited funds at a school (don't have budget to the 4x rack mount unit) and only run 2 of these cameras so this would be more cost effective to me and actually allow me to streamline my setup.

[Gary Adams]

As indicated in another thread, you can use a 2110 IP Mini BiDirect 12G converter, one for each camera to provide both SDI in and out for the ATEM at the ATEM end. These converters will not provide power to the camera, so that would need to be done by power at the camera or by using a PoE++ power injector for each camera. I hope this helps.

Gary