Blackmagic Forum

The Atem Control software overwrites the picture settings of our 2 cameras. Its not possible to change the picture settings like white balance or brightness on the camera itsself. It will be overwrited by the software and the software overwrites by itself to some default settings we didnt set.

Does anyone know about this problem?

If you connect cameras to Atem Control, then the software is the master to remotly setup and control the cameras.
Any change you make on the camera will be overwritten as the software is constantly updating.
This is correct and intended for remote control.

If you don't save the startup state then it will be reset to default or the saved state any time you start software control to the connected cameras.