Blackmagic Forum

Hi,

Just new to BMD. I have a BMD ATEM Mini Pro.

I use it without a laptop connected, and if the unit is power cycled, It reverts back to OOTB settings.
(input 1 selected, mic 1 & 2 off and so on)
Is there an option to either store "Default power on settings" or to run a macro when power on ?

Thank you

Yes .. U need to install atem software to computer .. And in ATEM Software Control , u have in menu FILE, item : SAVE STARTUP STATE .. This is what U are looking for ..

Hi Roman,

Thank you. It was exactly what I was looking for.

Regards,

Anders

Hi I'm using Atem Mini Pro for 2 years now but recently realised a small bug.
With latest firmware my Atem Mini Pro do not save current settings (Default Power Settings).
Used to have my Mic1 On and Auto Transition but now after restart my Mic1 is Off and CUT Transition active.
I'm 10000% sure it was always working (Autosave Status) but now even when I'm using Atem Software Control>File>Save Startup State - my Atem always starting with Mic1 Off and CUT Transition.
Other settings works.
Any help?

When you Save The Startup State you need to wait about 30 seconds before powering down to let it fully write to NVRAM. I hope this helps.

Gary