Blackmagic Forum

Hello everyone,

We keep encountering issues with the unbalanced MIC connection of the ATEM series due to ground loops.

Therefore, I would like to connect a Mini Converter Audio to SDI from the AES Out Port of an A&H SQ5 and use an SDI port on the ATEM for audio recording. Unfortunately, I can't find a cable from XLR to 1/4 inch (110 Ohm) connectors. Do you have any experience with this?

Thank you in advance,
Berni

Uh…ever heard of soldering ?

Just solder a 1/4” trs connector to a aes/ebu cable.

If you search aes ebu trs on Amazon a bunch of them will pop up.

Good Luck

Thank you for your tips,
I didn't find any products on Amazon, maybe because of my region.

Then I guess I'll have to solder.

Greets Berni

Im using basic audio cables trs to xlr for a lot of years .. and no issues ..