Blackmagic Forum

I've always streamed to YouTube using the Atem Mini Pro, but for the past week, YouTube has been giving me the error: "YouTube isn't receiving enough video to keep the stream smooth."

The strange thing is that I tested it using the secondary server and it works without this error.

Does anyone know if there was any change in the DNS on the primary server or if I need to change something on the Atem?

You and others have had this issue, as well as myself. Along with YouTube not connecting from the ATEM.

I spent two full days trying to get youTube to grab the signal from my ATEM and finally got it to work when I found a post about setting up Internet Sharing on my mac, which I've never had to do before. Now, I'm getting the same error you're asking about and was thinking of upping my cable speed from my provider. I did a speed test and was getting upper 20s, which should be more than fine.

I sure wish I knew what changed in the last few months because before that I was streaming with no issues and Internet Sharing was NOT engaged. This is so frustrating!

Good afternoon:

I spoke with a BMD Tech today and he stated that something is broken with the RTSP protocol on YouTubes end. Causes "YouTube isn't receiving enough video to keep the stream smooth" and cache pile up. States new software/firmware update in several weeks.

I set up OBS Studio and streamed to Youtube with no problem.


**Did you turn it off and back on?**

Hi,

Last week I upgraded the software to version 9.5.1, 2024.
Now I can stream on YouTube without the error "YouTube isn't receiving enough video to keep the stream smooth" and cache pile up.
I used the new "Custom URL H264" platform, although I don't understand exactly what it is.
I'm going to stream again this week and I hope it continues without problems.