XKEYS - JustMacros - ATEM 8.10.1 maximum
Posted: Mon Nov 04, 2024 1:33 pmHello, from firmware ATEM 9.xx JustMacros no longer detects the ATEM so the software does not work ... while with firmware 8.10.1 it is the last OK 
Blackmagic Forum
https://forum.blackmagicdesign.com/
XKEYS - JustMacros - ATEM 8.10.1 maximum
https://forum.blackmagicdesign.com/viewtopic.php?f=4&t=211154
Page 1 of 1
Posted: Mon Nov 04, 2024 1:33 pmRe: XKEYS - JustMacros - ATEM 8.10.1 maximum
Posted: Mon Nov 04, 2024 3:17 pmyou need new version of JUST MACROS I think ..
Re: XKEYS - JustMacros - ATEM 8.10.1 maximum
Posted: Mon Nov 04, 2024 5:07 pmNo more version since 2016....
Re: XKEYS - JustMacros - ATEM 8.10.1 maximum
Posted: Mon Nov 04, 2024 11:49 pmThat is the problem ..
Re: XKEYS - JustMacros - ATEM 8.10.1 maximum
Posted: Tue Nov 05, 2024 6:30 pmThe ATEM software also needed to be updated on the computer running the JustMacros software. This caught me once, so now I remember it.
I'm pretty sure my JM is working, and I am running ver 9.x -- that is on the task list to get all computers and switchers at common version.
I'm pretty sure my JM is working, and I am running ver 9.x -- that is on the task list to get all computers and switchers at common version.
Re: XKEYS - JustMacros - ATEM 8.10.1 maximum
Posted: Wed Nov 06, 2024 3:55 amHello, for the ATEM software to work with the mixer, it must be the same version. But I'm talking about JustMacros, on my PCwhen I install ATEM 9.xx, I can control the mixer with the ATEM software but the JustMAcros software no longer detects the ATEM... there's no solution!
Re: XKEYS - JustMacros - ATEM 8.10.1 maximum
Posted: Wed Nov 06, 2024 4:37 pmHmm...slept since I dealt with this. Try installing the ver 9.x SDK