Blackmagic Forum


https://forum.blackmagicdesign.com/

ATEM 4 M/E Constellation 4K -- Timecodes not matching

https://forum.blackmagicdesign.com/viewtopic.php?f=4&t=213303

Page 1 of 1

ATEM 4 M/E Constellation 4K -- Timecodes not matching

PostPosted: Tue Dec 10, 2024 7:45 pm
by bschwartz
Two Micro Studios connected to an ATEM 4 M/E Constellation 4K, with an Mini Sync generator plugged into REF IN and genlock set to Program in each camera. Testing genlock with a sync slate and I'm observing a 1 frame discrepancy in the timecodes between cameras. This is following previous tests where they matched. Is this a known issue?

Re: ATEM 4 M/E Constellation 4K -- Timecodes not matching

PostPosted: Thu Dec 12, 2024 10:02 am
by Xtreemtec
Settings and FW on both cameras exact the same?
Have you set the cameras to Sync on SDI in? and use the same offset in lines?