Hard Time Understanding IP Address of Studio Videohub 16x32
Posted: Thu Apr 17, 2025 3:29 pmHey everyone
So I'm a Qtake operator, so I need to use a videohub. I recently switched from a Smart 20x20 to a Studio Videohub 16x32. Difference between the two, is that the 20x20 was connected by ethernet, and now the 16x32 is connected by USB.
I'm a bit confused with the IP address behavior with the 16x32. USB is connected to a Caldigit TS3. In network settings I'm using DHCP with Manual Address, 169.168.1.100
When I open Videohub Setup (latest version, 10.1), sometimes the hub will be listed as 169.168.1.100, and then sometimes it'll be 127.0.0.1 (in a matter of seconds, just closing the setup window and opening it right back)
I have no clue why! And it's not something I can change within Videohub setup.
Any clue what should I do? Qtake is operating fine but every once in a while the software will crash, or the hub will stop being responsive.
So I'm a Qtake operator, so I need to use a videohub. I recently switched from a Smart 20x20 to a Studio Videohub 16x32. Difference between the two, is that the 20x20 was connected by ethernet, and now the 16x32 is connected by USB.
I'm a bit confused with the IP address behavior with the 16x32. USB is connected to a Caldigit TS3. In network settings I'm using DHCP with Manual Address, 169.168.1.100
When I open Videohub Setup (latest version, 10.1), sometimes the hub will be listed as 169.168.1.100, and then sometimes it'll be 127.0.0.1 (in a matter of seconds, just closing the setup window and opening it right back)
I have no clue why! And it's not something I can change within Videohub setup.
Any clue what should I do? Qtake is operating fine but every once in a while the software will crash, or the hub will stop being responsive.