Blackmagic Forum

Hi everyone,

i have updated the Adtem mini extreme ISO to the latest Firmware to gain access to the SSD, which is connected on the USB-C Port on the Atem. My setup is like this:

Atem Mini Extreme ISO:
USB-C > SSD Drive
USB-C > Docking Station > Laptop
Ethernet > Network-Switch > Router (DHCP)

To the Network Switch i have connected a 2nd Laptop so the routing is:
Atem Mini via Ethernet > Network Switch > Laptop 2.

On the 2nd Laptop i can see "Atem Mini Extreme ISO" on the Network Tab (Windows 11) but if i double click it, a error message appears with the code "0x80070035".

The first Laptop, which is connected via the Dockingstation directly to the Atem works fine.

Additional Info: I have plugged in the Network cable directly to my 1st Laptop and unplugged the USB-C cable form the Dockingstation and it also works fine. So my First Laptop has access to the SSD Drive via USB-C or Ethernet, 2nd Leptop not.