Blackmagic Forum

looking for help configuring a Black Magic ATEM switcher, Here's the issue:

I'm using an IMac hooking the ATEM TVS via ethernet and USB directly out of the Mac. The computer is networked via Wifi on a Subnet which has a different gateway 10.10.0.X range.

When I set the IP addresses to the spec in the manual which is in the 192.168.10.50 as a static manual address I can't connect to Wifi network if the Ethernet is plugged in. Anybody else overcome this problem?


The network is fine if I unplug the Ethernet and the switcher works fine.

Thanks

in network setting clear field GATEWAY and everything will work ...

or go into "set service order" in network setting (little gear icon at bottom) and move wifi to the top of the list...