Blackmagic Forum

Sometimes i have put the HDMI Multiview output with a 1m HDMI Cable to my Ultra Studio 3D or convertet the Signal HDMI-DVI to VGA with my Scaler without Problems. But now i if i connect that Equipment i become no Signal to this devices if i connect direct (Change Cable without luck). (HDMI,SDI Program Out no problem,SDI Multiview no Problem). But when i put between the devices a HDMI-Repeater i have a Signal (1m HDMI Cable-Repeater-1m HDMI Cable).
What is happen with the HDMI-multiview Output ? had BM changed something in the Firmware of the device? i have downgraded to 3.0,3.1 but nothing helps.

Thomas-kim

...i have no Problems to "get" a Signal in HDMI Displays from the HDMI Multiview out but in the configurations described.

I made the firmware-update and have no problem with TVS' multiview on HDMI-output.

"i become no Signal" means "i get no Signal" - tip for non german spaeking people

I have been using the HDMI Multiview out for some time now without any problems with numerous displays.

Hi! My name is Domingo.

I connect mi displays for the multi view and program in the Atem Television Studio HDMI Outputs, but I can see nothing in there. I don't understand what is the problem. I hope you can help me about this.

...i have no Problems to "get" a Signal in HDMI Displays from the HDMI Multiview out but in the configurations described.

Thomas-Kim

No issues here with the multiview out since the last FW update.

Make sure your TV/Monitor can handle the resolution you are using. From what I remember PC monitors get picky if using the 720P50 setting, as the multiviewer follows the resolution of the switcher.

Thank you! I solved it already. I think the problem was that I tried to connect a DVI cable. But change the DVI to HDMI cables and now is cool! But I have a new problem with the audio. I'm connecting the ada4 Aja converter to the input of the ATEM AES but I´m not receiving audio signal. Can anybody help?

Hello,

Have you confirmed the audio through the AJA converter? We're gonna be looking for unbalanced AES (or SPDiF) for that input.

I'd start with the simple. Confirm the audio output of the converter, and confirm the audio input of the switcher with another audio source (if you have one available).