Tue Mar 10, 2020 2:13 am
Glenn Venghaus wrote:Jacob Fenn wrote:
Route a signal generator (set to smpte) to any free output or track input (enable direct monitoring if track). Then switch on as Reynaud mentioned and press play and voila.
I routed it to a free hardware output and back to a free hardware input and into Reaper. Nice LTC sync. !! After an intial startup delay its in full sync wirh drift compensation (In Reaper)
LTC all still seems a bit dodgy ... and where exactly is this "Route a signal generator (set to smpte)"? The only item that comes close to this is Resolve's 'signal generator' (under Fairlight /test tone settings), but that does not offer SMPTE.
Otherwise, I eventually effected a kludge by using Fairlight /Remote Control Settings & enabling SMPTE. However, I had no way of monitoring if the Patch Input/Output routing was working or not because the timecode does not show up anywhere in the metering panel, or anywhere in the Fairlight page.
Is pure peck and hunt to see if the timecode is getting to where you want it to be.
MacPro 7,1 16 core, 192GB, MacOS 14.4.1, Vega II Duo. Antelope Pure 2 & Orion 32+, UA Apollo x8. RAID-4 Thunderbay 6, RAID-0 Sonnet M.2 4x4. MiniMon 4k, Dell U3415W & BenQ SW2700PT. Nuendo, Wavelab, Resolve Studio 18.6.6.