Mon Apr 20, 2020 6:18 pm
I'm going to throw in a couple questions here... I'm working with a HyperDeck Studio, and I am running RS-422 from Crestron to the deck. I am getting proper transport response to the basic commands, but I don't see commands that correspond to the "previous" and "next" buttons on the deck. Neither do I see (in the list of commands/responses in the manual) the responses I'm actually receiving from the deck when I send the transport commands. StatusSense command.
I send a transport command, and I receive \x10\x01\x11
I send StatusSense (\x61\x20\x81\x0D), and I receive \x11\x12\x04\x27
I'm trying to sort out the commands to get the time info (of the recorder's own generated time), but the commands for time are not documented well in the manual (I'm using a device with 2017 FW, thus that manual). Is there a command to get the right time from the recorder? It's a stand-alone system for recording rehearsals in a room with one camera; I just need them to be able to rewind or fast-forward or jog forward or back and get to a place in time that they can note and return to. Actual index markers would be nice, too.
EDIT: In the new software (March, 2020), I see an extension \x81\x03 BMDSeekRelativeClip, which looks like it will do what I need for "previous" & "next" commands. For the StatusData reply, I see I have to pull from the Developer chart. It looks like I'll be translating binary values for the byte to the hex values I need to receive...
Thanks,
Steven
EDIT: //PS: I'm going to start working on getting FW updated while I'm working on this issue...