Sat Jun 27, 2020 12:03 am
Hello Alain. to see the menu for setting the IP address you must connect a USB cable to the ATEM and run the ATEM Setup Utility. This cable needs to support data and not just a charging cable. If you still don't see the ATEM in Setup, check your "About This Mac"->System Report. Under both Camera and Audio there should be a Blackmagic Design device. If you do not see this, it could be a cable, connection or problem with the Mini. Sometimes a power cycle or re connection helps. You may need to contact Support in your region. Stay safe.
Regards, Gary
Gary Adams
Blackmagic Design