Same here, I need batch stabilization every day. I do the stabilization for dozens to hundreds of clips between 5 seconds and one minute.
Everytime the same process:
1. Selecting a clip
2. open the stabilizer (respectively changing to or within the color page, in cut page I open it only once, this is already optimized)
3. selecting "Translation" stabilization mode
4. stabilize
5. wait......
6. review it and maybe change a parameter and click "Stabilize" again (which are only a few milliseconds).
So for me setting the default stabilization mode is on top of my current wish list. Because "Perspective" looks so unnatural I mostly use the stabilization modes as follows:
Translation: 90%
Most of the shots with handheld gimbal just need a little smoother flow
Similarity: 9%
Some shots just shot handheld withoud gimbal were rotating a little, here I have to switch from "Translation" to "Similarity"
Perspective: 1%
I guess it's even less than 1% where I have the need to use "Perspective", because nearly every movement lets shake the whole image
So my workflow would be much faster with:
1. Setting the default stabilization in the resolve or project settings to "Translation" if possible and
2. stabilize all selected (maybe pre cutted) clips at once. Then I wouldn't have the downtime for a few seconds for every clip which sums up to hours for every project.
I guess I'm not the only one who could optimize his workflow with this features. As being a software developer myself I'd say that combining these already available functions with a batch mode and a default configuration is really no big deal but has an enormous effect.
Cheers
Marcus