- Posts: 2
- Joined: Wed Jan 13, 2021 8:17 am
- Real Name: Ilya Korolev
Wed Jan 13, 2021 8:23 am
Hello everyone
Just would like to start off with: this is my first post on this forum so apologies if I posted this in the wrong place, there was a previous answer to my question that I missed, or I did not provide enough detail about my issue.
My issue is: trying to connect the Cerevo FlexTally tally light system with my blackmagic television studio pro 4K. Does anyone have any experience connecting this hardware together?
I got the lights to communicate with each other but I cannot get the lights to switch with the ATEM. I’ve followed all of the troubleshooting in the official manual and still no luck. I believe it has something to do with the way I connected the lights to the LAN but I cannot figure it out. Any help will be appreciated, thanks.
Just would like to start off with: this is my first post on this forum so apologies if I posted this in the wrong place, there was a previous answer to my question that I missed, or I did not provide enough detail about my issue.
My issue is: trying to connect the Cerevo FlexTally tally light system with my blackmagic television studio pro 4K. Does anyone have any experience connecting this hardware together?
I got the lights to communicate with each other but I cannot get the lights to switch with the ATEM. I’ve followed all of the troubleshooting in the official manual and still no luck. I believe it has something to do with the way I connected the lights to the LAN but I cannot figure it out. Any help will be appreciated, thanks.
