Hi all, following this thread, good read!
I'm trying to connect an NX500 to Ultrastudio Mini Recorder, and like others have lost some hair over it. I've got the UMR working well with GoPro Hero3+, as well as an old Sony HC9 consumer camera. You really have to get the setting on the computer side right (in my case MBP 15" late 2013 model). It needs to be set to the native output of the camera, sometimes regardless of your video settings I found. ie the Sony only works when the Media Express project setting (or whatever software you're using) is set to 1080i50.
The Gopro's were working fine at 1080p25.
With the NX500, I was getting nothing! Until reading the forum and a post above mentioned some cameras working only at 720p. I set the HDMI Output of the NX to 720p, then the Media Express Project setting to 720p50, voila, there's a picture! Firstly there's a warning message on both the camera's screen and the capture window saying 'Shooting functions are supported only when the HDMI output is set to 1080p.'
So you can't get a live feed while in photo mode, but switch to video mode and it kind of half works!!
Half works in that you get the OSD, but no picture on either the camera or the capture window...
- Screen Shot 2015-10-22 at 3.40.35 PM.png (536.23 KiB) Viewed 59683 times
- Screen Shot 2015-10-22 at 3.41.54 PM.png (514.59 KiB) Viewed 59683 times
The ME project setting of 720p works when camera is set to PAL at 720p50, or NTSC 720p60, but when 60p you need to set the ME project to 720p59.97
Also works when the HDMI is set to lower resolutions. Just not 1080...
Any suggestions?
Maybe something to do with NX using h265 codec? Long shot...