SugoiSosu wrote:I am currently trying to get a cross dissolve effect to transition between 2 different clips of footage, but it was only applying the effect to the start of the second clip. So I cut an equal amount off the end of the first clip and start of the second clip and turned them into a combined clip. I applied the transition effect and positioning issue was resolved. However, the effect doesn't seem to have any sort of, well..., effect. the doesn't seem to be any transition at the halfway point of the clip and it just immediately cuts between the two. How do I sort this? Cheers.
If you're dealing with multiple clips, what you could try is stacking the clips on different tracks, and then do a series of individual fade-ins and fade-outs on each clip. That way, you could make one last longer than the others, some fade in half way and stay at that point, and other kinds of tricks frequently used in montages. Manual keyframes and Opacity in the Inspector would allow you do this, and you could also try the keyframe editor below the clip.