- Posts: 7
- Joined: Wed May 26, 2021 7:55 pm
- Real Name: Justin Castille
I could be wrong, but as long as you set the camera to output what is supported 6G signal (Resolution & framerate), and you set the switcher to run the same resolution and framerate, the switcher should have no issue using the image.
https://www.optcore.net/introduction-to-sdi/
This page has a chart showing the different standards. Basically 6G gets you everything up to 2160p@30.
The 12G of the URSA is because it supports framerates up to about 2160p@60