Denny Smith wrote:You can not change the resolution or frame rates from the Video Assist. In does not up/down or cross convert, except to take a UHD signal and down convert it to HD to display and record, since the VA is HD only. Frame rates are set by the camera connected to the VA, and the VA sets it recorder to match the incoming signal (except UHD is down converted to HD at the same frame rate as the original.
Your camera must be able to output a 1080p60 frame rate signal before the VA can record it. Once recorded, the VA sets its frame roster at the last recorded signal, and will only display files recorded at that frame rate. For example if your record a fi,e at 30fps, then one at 59.94 FPS, then you will only see the last file, I told you either disconnect the VA from the signal source and reboot it, then you will see both files.
Cheers
Thank you for your advice, after the post i searched it a lot and i found the answer, but i didn't manage to erase the post.
I would love to raise from 60fps to 100fps as my camera records (Sony a6500) for smoother slow motion.
Thank you for your time to answer
Cheers