Is it possible to Default Resolve Fusion to Mid Flow?

The "Mid Flow" Fusion Workspace layout preset -- Is it possible to set that as the default view somewhere so I'm not having to change it every time I start a session?

Still wondering this...

Still wondering this...

Save a workspace UI Layout Preset and it will stick

When using the vertical layouts, enabling the Flow > Build Direction > Vertical option in the Fusion settings. You can then save alternative layouts based on these two vertical presets using the Workspace > Layout Presets submenu.

sshot-1354.jpg (65.08 KiB) Viewed 701 times

I know how to set the workspace to Mid Flow.

The question is, how to have Fusion always open as Mid Flow by default.

how to have Fusion always open as Mid Flow by default.

I wonder if it will come down to this...

viewtopic.php?f=33&t=96350

I know how to set the workspace to Mid Flow. The question is, how to have Fusion always open as Mid Flow by default.

What's your point? That it the saved preset does not stay saved or what?

No the point is that it is difficult (if possible?) to set whatever preset one prefers as the default layout in the fusion tab.

I prefer "mid flow right", and each time i start resolve and go into the fusion tab, I have to switch to "midflow right". Sometimes even within the same session of resolve.

I know that i can probably set up a hotkey for it, but it would be much better if i could simply set "midflow right" as the default view for the fusiontab.

Can it be done?