Blackmagic Micro Converter 3D LUT Problem

I've recenlty purchased micro converter bidirectional SDI/HDMI 12g. The monitor is getting signal from hdmi out from this converter and converter get the signal from decklink 4k mini sdi port. I've calibrated monitor using calman software and uploaded 3D lut to the converter, but it generate delta error that is worse than pre calibration state. If I upload to Video Monitor Output in Resolve, then monitor is in almost perfect state , less than 1 delta error. Is Lut function in micro convert working, or am I missing something?

What format and size are the LUTs you're pushing to the converter?

What format and size are the LUTs you're pushing to the converter?

it's 33 general cube generated from calman cube generator.

it's 33 general cube generated from calman cube generator.

Hey, did you solve the issue? How? Thanks!!!!

I'm encountering exactly the same problem. Using ColourSpace to generate the LUT. Does anyone have a fix?

solving this might be nice 17 point luts also have problems