Clone Stamp Tool Fusion MAC

I am unable to offset the clone stamp tool on the mac version of Fusion 8. Is there a modifier key or letter that is supposed to do this?

ctrl is mapped on macs as right click, so I believe that is interfering with the key.

Also changing the offset numerically seems to offset the source by a huge margin. even going from .5 to .57 moves the offset 40 pixels away.

I am unable to offset the clone stamp tool on the mac version of Fusion 8. Is there a modifier key or letter that is supposed to do this?

ctrl is mapped on macs as right click, so I believe that is interfering with the key.

Also changing the offset numerically seems to offset the source by a huge margin. even going from .5 to .57 moves the offset 40 pixels away.

Fusion uses relative coordinates. It is resolution independent.

I have the same question..