Drag DVE anchor

Having trouble finding an answer for this... can I drag the anchor of a DVE so that it scales and rotates from that point rather than the default centre?

Yes. The term you're looking for is the Pivot. It's the green "X" in the Viewer, but it's unfortunately impossible to select it while it's hiding behind the Center handle. You can make it the active control by using the little pop-up menu in the lower-right corner of the Viewer:

Untitled.jpg (21.65 KiB) Viewed 1405 times

Or you can move it away from the Center by entering a value other than 0.5 in one of its coordinates in the control panel.

That's exactly what I needed to know - Thank you!

Also, when the view is active, pressing TAB will cycle through the various options (angle, pivot etc)

Cool, thanks!

Nice! Always something new to learn.

Also, when the view is active, pressing TAB will cycle through the various options (angle, pivot etc)

Nice! It works for the transform tool also.

It works for every tool with on-screen 'widgets' .