Please make only Fusion clip frames show by default.

When creating a Fusion clip, it is constantly driving me crazy that the Timeline shows me all the frames for my entire timeline, rather than the frames of the Fusion clip I'm working on. It's annoying to have to trim the little work area bar every time for every clip just to isolate the frames I want to be working on. There hasn't been a single time yet that I've needed to view all the frames of my timeline while in a Fusion Comp.

Please change it so that only the frames of the Fusion clip are shown by default. Or at the very least give us a button or a right-click toggle that will snap it to show only those frames.

***And while you're at it please put the timeline back at the bottom like Fusion Studio.

Thanks!