Problem with ATEM 1, hdmi input or audio mixer

Hello, I have the ATEM 1 Production Switcher, HDMI inputs with software 3.1.1 works fine but I have not the audio mixer. Updated to version 3.2 or 3.3, the audio mixer works but hdmi inputs do not work. An update that fixes that, I tried different resolutions and hz and does not work with version 3.2 or 3.3. Lower to version 3.1.1 and hdmi works but I run out the audio mixer. Waiting for an early reply.

regards

Daniel

Many posts here about this issue (just search for "60Hz HDMI") it's related to Black Magic removing their unofficial "support" for 60hz device while the ATEM runs in 59.94Hz mode. They have acknowledged the issue and stated they are committed to re-implementing it ASAP - but with NO NO NO guarantee when they'll fix it. Meanwhile the fix is to keep on 3.1.1 or have problems with our other devices.

With software version 3.1.1 hdmi works, but the audio mixer does not work. When upgrading to use the mixer hdmi lose functionality. I do not understand if it worked fine before now, and my laptop goes 1080I 59.94Hz and others too.

The audio mixer controls were first implemented in Firmware release 3.2. That's why it doesn't work in 3.1.1 and below.

However, as I said, 3.2 and above BROKE many devices that were previously working with HDMI inputs.

Check this post with a comment from BMD about this.
viewtopic.php?f=4&t=419&p=3533&hilit=1080i60#p3533

Ok thanks, i'm wait for fix this problem.